Cannabis | Marijuana > Cannabis General

Make Rick Simpson Oil. Cure Cancer | Manage Pain

(1/3) > >>

Galaxy Admin:
http://anewwe.org/tips-recipes/how-to-make-hemp-oil-by-rick-simpson/

Rick Simpsons process of making hemp oil
Starting material:
I generally work with a pound or more of good grade hemp starting material. You can use just one ounce. An ounce will usually produce 3 or 4 grams of oil. The amount of oil produced per ounce of hemp will vary from strain to strain, but it all has that wonderful healing power.

1 - Place the completely dry starting material in a plastic bucket.

2 - Dampen the material with the solvent you are using. Many solvents can be used.  You will require about two gallons of solvent to strip the THC off one pound of dry starting material. 500 milliliters of solvent should be more than enough to strip the THC from one ounce of starting material. (Editors note: For more information about which solvent to use visit the Facebook group Cannabis Oil Success Stories)

3 - Crush the plant material using a stick of clean untreated (chemical free) wood or some such device. Even though the starting material has been dampened with the solvent, you will find that the material can be readily crushed.

4 - Add solvent until the starting material is completely covered.
Use the stick to work the plant material. As you are doing this, the THC dissolves off the plant material into the solvent.

5 - Continue this process for about 3 minutes.

6 - Pour the solvent-oil mix off the plant material into another bucket. You have just stripped the plant material of about 80% of its THC.

7 - Second wash – again add solvent to the plant material and work it for another 3 minutes to get the other 20%.

8 - Pour this solvent-oil mix into the bucket containing the first mix that was poured off previously.

9 - Discard the twice-washed plant material.

10 - Pour the solvent-oil mix through a coffee filter into a clean container.

11- Boil the solvent off. I have found that a rice cooker will do this boil off very nicely. The one I have has two heat settings – high and low – and will hold over a half gallon (2.5 liters) of solvent-oil mix.

12- Add solvent-oil mix to the rice cooker until it is about ¾ full.

Make sure you are in a very well ventilated area and set up a fan to carry the solvent fumes away. The fumes are very flammable. Be sure to stay away from red-hot elements, sparks, cigarettes etc. that could ignite the fumes.

13 - Plug the rice cooker in and set it on high heat.

14 - Continue adding solvent-oil mix as the level in the rice cooker decreases until it is all in the cooker.

15 - Add a few drops of water to the solvent-oil mix as the level comes down for the last time. The amount of water added depends on how much starting material you had in the beginning. If I am producing oil from a pound of good bud, I usually add about ten drops of water.

16 - When there is about one inch of solvent-oil-water mix left in the cooker, put on your oven mitts, pick the unit up and gently swirl the contents.

17 - Continue swirling until the solvent has been evaporated off. The few drops of water help release the solvent residue and protect the oil somewhat from too much heat. When the solvent has been boiled off, the cooker that I use automatically goes to low heat. This avoids any danger of overheating the oil. At no time should the temperature of the oil go over 290F degrees (140 C).

18 - Put on your oven mitts and remove the pot containing the oil from the rice cooker.

19 - Gently pour the oil into a small stainless steel container.

20 - Place this container in a dehydrator or put in on a gentle heating device such as a coffee warmer. It may take a few hours but the water and volatile turpines will be evaporated from the oil. When there is no longer any activity on the surface of the oil the medicine is ready for use.

21 - Pour the hot oil into a bottle; or as in the video suck it up into a plastic syringe. Putting the oil in a plastic syringe makes it very easy to dispense the medicine.

When the oil cools off it has the consistency of thick grease. Some strains will produce very thick oil and you may have trouble squeezing it out of the syringe. If this happens, place the syringe in warm water a few minutes prior to use.

To anyone starting to use hemp oil as a medication, here are some simple facts.
Hemp oil will lower blood pressure and if you are on blood pressure medication, you may find that this medication is no longer needed. The same is true for diabetics. I have seen hemp oil control blood sugar to the extent that insulin was no longer needed.

I am not a doctor and I do not have the right to tell people what they should do. Personally, I would not consider taking any cancer treatments currently in use by our medical system, I do not recommend that hemp oil be taken along with chemotherapy. What would be the sense of making your own cure and then allowing the medical system to give you massive doses of poison?

From my experience with hemp medicine, I have found that most pharmaceutical medications are no longer needed once a person starts using hemp oil. Hemp oil seems to mix well with most natural medications but I have had a few reports from people trying to take hemp oil and pharmaceuticals who experienced stomach pain etc. All problems ceased when they stopped taking the prescription drugs.

To anyone who is going to act on this information to help a loved one, I welcome you to the world of real medicine. Again, I caution you to be very careful when boiling the solvent off. The fumes are very flammable. Be sure to stay away from red-hot elements, sparks, cigarettes etc. that could ignite the fumes.

I wish you the best luck and health.
Warmest regards,
Rick Simpson.

tibeirious:
 :goodpost

that was awesome, easy to follow and very doable..

I have been wanting to try this for a while...

what a miracle plant..

D3Dman:
The quality of the starting material directly correlates to the quality of the final product, as well.

tibeirious:
oh...so my idea of buying a pound of leaves and stems from a dealer to make this would probly not turn out like I want it to...


well I have 2 grams of good weed ..what can I make with that? lol

I need three more jobs..

 :smokebanana

toy:
would love to make some of this for my Dad

Navigation

[0] Message Index

[#] Next page